Multi-unit restoration

Screw retained restoration

1. Straight Multi-Unit

Straight Multi-Unit – an abutment connection to an implant can be mounted at six different heights:

2. 18° and 30° Angled Multi-Unit

18° and 30° Angled Multi-Unit abutments are available in three different heights: H00, H01, H02

3. Angular Adapter

An Angular Adapter can be mounted at three different angles: Recommended in cases when soft tissue thickness is more than 4 mm.

4. Multi-Unit Cover

Multi-Unit Cover – Can be mounted at four different heights:

5. Angle and height clip gauge

Angle and height clip gauge – use the Gauge Kit for angle and height selection

Using the angle gauges gives you an option to pre-plan the use of the abutment in order to achieve maximum parallelism.

6. Multi-Unit connection

Multi-Unit connection – use the holder to place the base connection into the implant

Multi-Unit abutments attached to the implant

STEP ONE:
Multi-Unit base connection – use the holder to place the base connection into the implant

STEP TWO:
Match the Multi-Unit cover abutment height 2-5 mm as required

Closed tray impression coping

Closed tray impression coping – with plastic cap

Snap-on to secure positioning & Use Closed-tray impression coping

Open tray impression coping

connect the transfer onto the abutment. Inject impression material and position the impression tray

Inject impression material and position the impression tray.
Send the impression tray to the laboratory

In cases when a two-stage surgery is indicated:

Healing procedure – connect the temporary restoration healing cap

The original denture can be used on top of the healing caps while the temporary denture is being produced

The original denture can be used on top of the healing caps while the temporary denture is being produced

The screw geometry was carefully designed and optimized to allow safe tightening and long service. Special attention must be paid while tightening the screw. Make sure to use an original SURCAM hex key with edges that do not show wear. It is recommended to purchase additional screws

Simple immediate restoration implantation

The sleeves height needs to be trimmed to the desired height